Step 4: Integration of the charging stations, control and monitoring

On the portal https://floem.clemap.com you set the configuration of the charging stations under the menu item "Load Management Setup".

Figure 12

Alternatively, the settings can also be made via the local CLEMAP load management server. If the device is connected to the network via Ethernet cable, it can be reached via the address http://clemapXX:4000 - where "XX" corresponds to the last two digits of the serial number. Example: For serial number SE08012345, the local address is http://clemap45:4000. Alternatively, access is also possible directly via the local IP address: http://IP_ADDR:4000. The current IP address of the CLEMAP device (e.g. 192.168.27.34) can be viewed in the router.

Figure 13 Local configuration of load management

Select Load Management from the menu and configure the load management settings and the connections to the charging stations. Further instructions for the installation of specific charging station models can be found here: Compatible charging stations

After completing the installation, it is possible to manage the installations via the CLEMAP Floem portal.

Figure 14

The following information is available in CLEMAP Floem:

· Status of the charging station: free, occupied, charging, discharging, not in operation

· With a CLEMAP Floem licence BASIC, you can dynamically control and adjust the limit of the charging stations in real time via the CLEMAP Floem portal.