Pezag Eco Duo

1\ access to the web interface make sure your device is connected to the local network use software such as advanced ip scanner to find the ip address of the device open a web browser and enter the ip address of the device in the address bar log in with the default credentials username manufacturer password manufacturer 2\ network configuration navigate to the network under the ethernet tab, activate the automatic assignment (dhcp) option this allows the device to automatically obtain an ip address from the network 3\ configuration modbus go to the modbus section set the modbus start register to 1, which is the default setting 4\ configuring the charge points for each charge point, proceed as follows 1\ define the name and location of the charge point go to the charge point configuration tab enter the desired name and location 2\ set locking mode set locking mode to on ev connected disconnected this ensures that the charge point will be locked or unlocked depending on the connection status of the electric vehicle 3\ define the charging current parameters set the following parameters for the charging current minimum charge current set to 6a (or your preferred value) maximum charge current set to 22a (or your preferred value) fallback charge current set to 6a (or your preferred value) 4\ set the meter type select the correct meter type installed in your device for example phoenix contact eem em357 phoenix contact emm dm357 you can find this option in the meter type section select the current meter type fitted in the device (e g phoenix contact eem em357 / emm dm357) 5\ save the configuration once all the settings have been made, be sure to save the configuration for each charge point the settings can be exported and used and adapted on another chargepoint