---
title: Keba P40
slug: help-center/keba-p40
docTags: 
createdAt: 2023-09-08T17:20:53.137Z
---

:::hint{type="warning"}
For the P40, the settings must be made in the corresponding app and not in the browser.

The app can also be used for the P30.

**Android:** Google Play Store – KEBA eMobility App

**iOS:** App Store – KEBA eMobility App
:::

# Setting up the KEBA KeContact P40 for CLEMAP

This guide describes how to configure the network connection, enable Modbus TCP and add the charging station to Floem.

## 1 Requirements

The following information and equipment are required:

- KEBA eMobility App
- Bluetooth enabled on the mobile device
- Charging station PIN
- Installer PWD
- Access to the LAN or Wi-Fi credentials
- Charging station switched on

The PIN and Installer PWD can be found on the sticker on the back of the supplied quick-start guide.

## 2 Connecting via Bluetooth

1. Install the KEBA eMobility App on the mobile device.
2. Enable Bluetooth on the mobile device.
3. Make sure that the charging station is switched on.
4. Remain within 10 metres of the charging station.
5. Open the KEBA eMobility App.
6. Select the charging station. If it is not displayed, add it using the + button.
7. Enter the charging station PIN.
8. Select the Installer role and enter the corresponding Installer PWD.

The Bluetooth connection to the charging station is now established.

## 3 Configuring LAN or Wi-Fi

1. Establish a Bluetooth connection to the charging station in the KEBA eMobility App.
2. Open Network Connection or the Network Configuration Wizard.
3. Select the required connection:
   - For LAN, make sure that the network cable is connected correctly.
   - For Wi-Fi, select the required network and enter the Wi-Fi password.
4. Save the settings and wait until the charging station connects to the network.
5. Check the IP address assigned to the charging station in the device information.

Use the IP address of the connection that is actually being used:

- Network cable: LAN IP Address
- Wi-Fi connection: WLAN IP Address

Make a note of this IP address. It will be required when adding the charging station to Floem.

**Important:** Do not continue with the Modbus configuration until the charging station can be reliably reached via LAN or Wi-Fi.

## 4 Enabling Modbus TCP

1. Open the charging station in the KEBA eMobility App and go to Settings.
2. Select Show advanced settings at the bottom of the screen.
3. Open Modbus.
4. Switch on Enable. The switch must be displayed in green.
5. Check the following values\:Keep the default values unless different values have been specified for the installation.
   - Port: 502
   - Unit ID: 255
6. Scroll down to Failsafe Timeout.
7. Set Failsafe Timeout to 300 seconds.
8. Select Save in the upper-right corner.

**Important:** The Failsafe Timeout must be set to 300 seconds and saved.

## 5 Adding the charging station to Floem

1. Open the required installation in Floem.
2. Add a new charging station.
3. Enter the following settings:

![](https://api.archbee.com/api/optimize/N5BtsfQVOxPnQzfUQkalm/6F3Hmy0LhwajryYKYvuS1_screenshot-2026-09-11-at-163932.png)