How do I configure the outputs (relays) on the CLEMAP Load Management system? (cloned)

the clemap load management system has two relay outputs ( out a and out b ) that can be automatically opened or closed depending on the configuration these outputs can be used, for example, to control a contactor or activate other external components important note the relays do not supply their own voltage if voltage is required at the output, they must be powered by an external 24 vdc power source the configuration of the outputs is done directly on the device via the following menu device config > external output mapping if you have any further questions or specific use cases, our support team will be happy to assist you if you have any further questions or specific use cases, our support team will be happy to assist you